Fence Company in Brownsville, TX
Fence and Gate Repair in Brownsville, TX
Repair storm damage, leaning sections, rotted posts, rusted metal and sagging gates on any type of fence.
Storms, salt air and humidity take a toll on Brownsville fences, but most damage can be fixed without starting over. Tell us what's wrong and we'll match you with a local fence and gate repair contractor.
Request a Free Quote
Common fence problems in Brownsville
- Sections leaning or knocked down after a storm
- Wood posts rotted or eaten by termites at the ground
- Loose, broken or missing boards
- Black streaks and loose boards from rusted nails
- Rust on steel posts, rails, welds and hinges
- Vinyl panels blown out of their posts
- Chain link sagging or torn
- Gates that sag, drag or won't latch
Repair or replace?
Repair makes sense when the damage is limited to some posts, a few boards or panels or the gate. Replacement is usually the better value when most posts are failing, the fence leans along its whole length or repairs would cost close to half the price of a new fence. A good contractor will give you a straight answer.
Why coastal fences fail
- Posts rot or rust at the ground. Constant moisture and termites attack wood posts, and salt air corrodes steel posts where the coating is damaged.
- Fasteners corrode. Plain steel nails and screws rust in salt air, loosening boards and staining wood.
- Soft ground shifts. Near resacas and low areas, footings can tilt after heavy rain.
- Storm wind. Solid fences catch the wind and pull on posts and gates.
Fixing the cause, not just the symptom, keeps the repair from failing again. That often means switching to galvanized steel posts, stainless fasteners or deeper footings.
Repairs by fence type
- Wood: replace rotted posts (ideally with steel), swap broken boards, refasten with stainless screws, add a rot board at the bottom.
- Metal: clean and recoat rust, weld broken pickets and rails, replace badly rusted sections with aluminum or powder-coated steel.
- Vinyl: reset blown-out panels, replace cracked panels and rails, reinforce posts.
- Chain link: re-stretch sagging mesh, replace bent top rail, fix ties and repair torn sections.
Gate repairs
Gates take the most wear. A sagging gate usually means a leaning hinge post, worn or rusted hinges or a frame that's too weak. Resetting the post, upgrading to galvanized or stainless hinges, adding an anti-sag kit or reinforcing the frame typically fixes it. Gate repairs are among the most common small jobs.
After a storm
- Stay away from downed power lines and call the utility.
- Photograph all damage before moving anything.
- Contact your insurance company, since wind and falling-tree damage may be covered.
- Secure pets, since a damaged fence is an easy escape route.
- Call us and we'll match you with a contractor who handles storm repairs.
After major storms, contractors fill up fast. Calling early helps.
What affects the price
The amount of damage, the fence material, access to the area and how easy it is to match existing materials all affect the cost. Most repairs cost far less than a new fence.
Preventing the next repair
Each spring, before hurricane season, walk your fence. Push on every post, check gates, tighten loose boards and hardware, touch up rust and rinse off salt. Fixing small problems early keeps a storm from turning them into big ones.
Repairs for rental and commercial properties
Landlords and business owners often need fast, practical fence repairs: a gate that won't lock, a section knocked down by a vehicle, or storm damage that leaves a property unsecured. Contractors who handle repairs can often secure the property quickly and come back for a permanent fix if parts need to be ordered.
Upgrading while you repair
A repair is a good time to make the fence stronger. Swapping rotted wood posts for galvanized steel, replacing plain nails with stainless screws or putting heavier hinges on a gate costs a little more during the repair and can add years to the fence. Ask the contractor which upgrades make the most sense for your fence.
How fence and gate repair works
Describe the damage
Tell us what's leaning, broken or rusted. Photos help the contractor plan.
Inspection
The contractor checks posts, footings, fasteners and hardware to find the real cause.
Repair
Posts are reset or replaced, panels and boards swapped, rust treated and gates realigned.
Cleanup
Damaged materials and debris are hauled away.
Related services in Brownsville
- Wood Privacy Fence in Brownsville: Cedar and pine privacy fences on galvanized steel or wood posts, built for Brownsville's humidity and storms.
- Aluminum and Iron Fence in Brownsville: Rust-proof aluminum and powder-coated iron fences for front yards, pools and waterfront lots near the coast.
- Vinyl Fence in Brownsville: Low-maintenance vinyl privacy and picket fences that won't rot, rust or need painting in Brownsville's coastal air.
Not sure which service you need? Tell us about the job and we'll point you to the right pro.
Fence and Gate Repair FAQs
Often. If posts are intact, sections can be reset in new concrete. Broken or rotted posts need replacing.
Talk to a fence company pro in Brownsville
Call (956) 335-9568 or request a free quote online. Brownsville Fence Company connects you with a vetted local pro.